Updated Dec-2025 GB0-713 Exam Practice Test Questions [Q43-Q60]

Rate this post

Updated Dec-2025 GB0-713 Exam Practice Test Questions

Verified GB0-713 dumps Q&As 100% Pass in First Attempt Guaranteed Updated Dump

Q43. There are 4 900G SAS hard disks. In the storage system, the raid10 strategy is adopted. The maximum volume capacity that these 4 hard disks can form is

3600G

1800G

900G

2700G

Q44. Which of the following statements about virtual machine mounting storage is correct?

The virtual machine can directly access physical storage mounts through the network

The virtual machine can mount the storage volume on the CVK as a block device

You can create a new file in the CVK mounted storage pool and mount it to the virtual machine for use

Multiple virtual machines can mount the same disk file

Q45. Servers are classified into the following categories according to their processor architecture:

RISC architecture server

Blade Server

X86 server

I A-64 Server

Q46. Which of the following descriptions about virtual machine high availability HA is correct?

HA functionality provides easy-to-use, cost-effective availability for applications running on all virtual machines in a cluster.

After enabling the HA function, CVM will continuously monitor the operation of all server hosts and virtual machines in the cluster. When a host or virtual machine fails, CVM will immediately respond and restart all affected virtual machines on other available hosts in the cluster.

After the cluster enables the HA function, all hosts in the cluster are required to mount the system shared storage

After the cluster enables HA, all virtual machines in the cluster have HA enabled, and the HA function of a single virtual machine cannot be disabled.

Q47. Which of the following statements about the default gateway is incorrect?

After installing the CAS software, the management network gateway is used as the default gateway by default

The server where the CAS system is installed can be configured with multiple default gateways

If the storage network does not run Layer 3, there is no need to configure static routing locally

If the storage network runs at Layer 3, you need to configure static routing locally

Q48. The following modification of virtual switch port information is incorrect.

To modify the host management vswitch address, you need to delete the host from the CVM page.

Modify the host service vswitch binding physical port can be modified directly on the CVM page

Changing the host storage vswitch address requires suspending the shared storage pool

To modify the host management vswitch name, you can directly modify it on the CVM page.

Q49. Which of the following is correct about the common maintenance commands of CAS?

virsh list can view all running virtual machines on the host.

virsh pool-list -all can view the storage information mounted on this cvk host.

qemu-img info command can view virtual machine disk information

After executing the service apache restart command, all tasks running in the foreground will be interrupted.

Q50. Which of the following are characteristics of cloud computing?

Self-service

Resource pooling

Flexible Scheduling

Services are quantifiable

Network distribution

Q51. Which of the following statements about CAS characteristics is correct:

When a server fails, DRS can automatically select a space server and restart the VM on an idle server.

V2V supports converting virtual machines in various formats such as VMware, Citrix, KVM, etc. into H3CCAS virtual machines

HA takes into account the virtual machine CPU, memory, I/O throughput load factors and the virtual machine’s affinity to the physical host to dynamically adjust the distribution of business loads and improve system availability.

DRX takes into account the virtual machine CPU, memory, I/O throughput load factors and the virtual machine’s affinity to the physical host to dynamically adjust the distribution of business loads and improve system availability.

Q52. Which of the following statements about virtual switch link aggregation is correct?

If the virtual machine switch is configured with “static link aggregation” and the load sharing mode is “basic load sharing”, static aggregation should be configured on the physical switch

If the virtual machine switch is configured with “static link aggregation” and the load sharing mode is “active/standby load sharing”, aggregation should not be configured on the physical switch.

If the virtual switch is configured with “dynamic link aggregation”, the connected physical switch must also be configured with dynamic aggregation

If the virtual machine switch is configured with “static link aggregation” and the load sharing mode is “advanced load sharing”, static aggregation should not be configured on the physical switch.

Q53. The incorrect statement about installing the CAS system through HDM (or ilo) is

The management server needs to install CVM, but the business server does not need to install CVM

The interface address configured during installation is the business network port address

After the installation is complete, you need to confirm the image file selection in the virtual drivers menu. The ISO file has been disconnected.

There is a trial period after CAS is installed. It is recommended to register for a formal license during this period.

Q54. Which of the following statements about configuring a virtual switch is incorrect?

The uplink port of the virtual switch allows all VLANs to pass

The virtual switch uses the vNer0 port of the virtual switch, and the port is configured with VLAN 100. Then the physical switch port connected to the virtual switch must allow VLAN 100 to pass through, otherwise the virtual machine cannot communicate with the external network.

When adding a virtual switch, you must bind a physical interface, and when binding multiple physical interfaces, you must configure link aggregation mode and responsibility sharing mode.

The storage virtual switch must be configured with an IP address, otherwise the CVK host cannot mount the IP SAN storage through the storage virtual switch.

Q55. The correct statements about UIS Manager are:

UIS Manager can be embedded in the blade switch to manage UIS8000 blade frame

UIS Manager can be used to manage the M8300 itself

UIS Manager can manage UIS Pack cabinets

UIS Manager can be embedded in TOR switch to manage rack servers

Q56. What functions does one-key inspection support?

Support one-click health inspection

Support one-click resource analysis

Support one-click storage cleanup

Support one-click resource export

Support one-click virtual machine restore

Support one-click zombie virtual machine processing

Q57. Which of the following statements about cloud service processes is incorrect?

Users can apply for an empty virtual machine in a customized way and use a virtual CD-ROM to install the virtual machine operating system

The cloud host with the cloud disk loaded cannot be logged out. You need to uninstall the cloud disk first.

Organization users can only be created by administrators

Organization administrators can publish cloud messages for the organization users they manage.

Q58. Which of the following errors regarding virtual machine migration is

Virtual machine migration refers to manually migrating a virtual machine to a different host and data storage, supporting offline migration and online migration

Virtual machine migration includes changing the host, changing the storage, changing the host and storage

When the virtual machine only changes the host, the destination host must be able to access the image file of the virtual machine

Changing the host and storage means migrating the virtual machine to another host and migrating the virtual machine image file to other storage on the host. Only offline migration is supported.

Q59. Regarding storage pools, the following statements are incorrect:

A shared file system can be mounted by multiple servers

ISCSI network storage can be assigned to virtual machines after being mounted on the host

NFS network file system can be accessed by multiple servers

There is no limit on the number of hosts that can mount the same shared file system

Q60. Which of the following descriptions about virtual machine high availability (HA) is correct?

HA functionality provides easy-to-use, cost-effective high availability for applications running on all virtual machines in the cluster.

After the HA function is enabled, CVM will continuously monitor the operating status of all server hosts and virtual machines in the cluster. When a host or virtual machine fails, CVM will immediately respond and start all affected virtual machines on other available hosts in the cluster.

After the cluster enables the HA function, all hosts in the cluster are required to mount the system shared storage

After the cluster enables the HA function, all virtual machines in the cluster have HA turned on, and the HA function of a single virtual machine cannot be turned off.

Pass H3CNE-Cloud GB0-713 Exam With 86 Questions: https://www.real4dumps.com/GB0-713_examcollection.html

Updated Dec-2025 GB0-713 Exam Practice Test Questions [Q43-Q60]

Leave a Reply Cancel reply

Related Posts

GB0-961 Dumps PDF 2023 Program Your Preparation EXAM SUCCESS [Q14-Q35]