[Jan-2024] HPE6-A72 Pre-Exam Practice Tests Exam Questions and Answers for Aruba Certified Switching Associate (ACSA) V1 Study Guide [Q36-Q54]

QUESTION 36
Which Ethernet port combination does the Aruba 5400R ZL2 switch series support?

QUESTION 37
Refer to the exhibit.

The above output is the result of issuing the command show system resource-utilization.
What command should be used to enable terminal output line by line or page by page?

QUESTION 38
Which field in the IPv4 header indicates whether the IP packet carries TCP or UDP traffic?

QUESTION 39
Click on the colored box that corresponds with the line that best represents Broadcast traffic flow.

QUESTION 40
What are two primary concerns regarding layer two loops in a redundant topology? (Choose two.)

QUESTION 41
The section in blue can be ignored.
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

QUESTION 42
What is a benefit of choosing a 3-Tier design with routing at the Aggregation layer?

QUESTION 43
You need to remote into an AOS-CX switch using SSH in order to update the management IP address for future connections. Unfortunately, you mis-configured the IP address and are now locked out of the switch.
What command could you have issued before making changes that would have recovered the original switch configuration after ten minutes?

QUESTION 44
Refer to the exhibit.


What command will display the debug l2mac events?

QUESTION 45
Click on the colored box that corresponds with the line that best represents Broadcast traffic flow.

QUESTION 46
Which switch supports a maximum of 8 line-cards, 3 fabric modules, and 2 management cards?

QUESTION 47
What is the login and password combination is used when first configuring an Aruba OS-CX switch from factory defaults?

QUESTION 48
Refer to the exhibit.

What command (output shown above) gives the optics serial number and part number information?

QUESTION 49
The section in blue can be ignored.
SW1(config)# interface 1/1/1-1/1/2
SW1(config-if-<1/1/1-1/1/2)# vlan access 2
SW1(config-if-<1/1/1-1/1/2)# exit
SW1(config)# interface 1/1/11-1/1/17
SW1(config-if-<1/1/11-1/1/17)# vlan access 17
SW1(config-if-<1/1/11-1/1/17)# exit
After completing the above commands, what is the expected output of show vlan with no other vlan commanded having been added?

QUESTION 50
Refer to the exhibit.

What commands will successfully enable the SVI for vlan 100 on interface 1/1/1 to produce the results displayed in the command show ip interface brief in the exhibit below?

QUESTION 51
Which two statements accurately describe stacking with Aruba switches? (Choose two.)

QUESTION 52
What is an available command on an Aruba AOS-CX switch that would back up the secondary image to a secure remote repository?

QUESTION 53
Which two port characteristics must match between LAG interfaces? (Choose two.)

QUESTION 54
Which statement is true regarding modern switching requirements?