2023 Correct and Up-to-date Juniper JN0-250 BrainDumps [Q15-Q34]

Q15. Which statement is correct about Wi-Fi?

Q16. Mist Radio Resource Management makes dynamic changes to which resource?

Q17. A customer wants to physically wire their interior automated sliding doors to Mist APs to directly control location access to certain office areas.
In this scenario, which Mist AP capability allows them to accomplish this task?

Q18. What would cause 5 GHz interference?

Q19. Which underlying technology does Mist use to calculate BLE location?

Q20. What does RSSI measure?

Q21. You have discovered an access point that is not connected to the corporate network but it broadcasts the corporation’s SSID.
In this scenario, what is this type of access point called?

Q22. What are two methods of activating a Mist AP? (Choose two.)

Q23. Which characteristic describes Mist’s cloud software architecture?

Q24. Which statement is correct about Mist Edge?

Q25.

Referring to the exhibit, what do you determine about the site’s Time to Connect SLE metric?

Q26. Which SLE would you use to determine Wi-Fi interference?

Q27. The DHCP server has run out of address leases on a site.
In this scenario, which SLE would be useful to what is happening?

Q28. You have designed a WLAN to satisfy primary coverage, secondary coverage, and capacity requirements. However, you still do not have enough BLE radios to satisfy your location requirements. You want to fill the gaps with a low cost, BLE-only device.
Which Mist device will satisfy this requirement?

Q29. You are configuring your Mist network and you want to separate certain users into their own networks and VLANs. You are concerned about the network’s utilization and want to make sure that only a single SSID is sending beacons.
In this scenario, which feature would accomplish this behavior?

Q30. What are two characteristics of the 2.4 GHz band when compared to the 5 GHz band? (Choose two.)

Q31. You are troubleshooting a WLAN from a mobile handheld device that displays radio information. You see a signal on the same SSID from two separate access points (APs). AP A shows a signal strength of -57 dBm and AP B shows a signal strength of -72 dBm.
In this scenario, which statement is correct?

Q32. You configured an 802.11n AP to use the 2.4 GHz frequency band and 20 MHz channel width.
In this scenario, how many non-overlapping channels are available for clients to use in Europe?

Q33. Which organization is responsible for WLAN standards?

Q34. Which Mist feature provides an overview of the user experience?