H35-480_V3.0 Dumps To Pass Huawei Exam in 24 Hours – Real4dumps [Q14-Q38]

QUESTION 14
Which of the following is the correct sequence for adding gNodeB hardware?

QUESTION 15
5G wireless network cloudification can significantly improve the user rate.

QUESTION 16
Which of the following statements about the functions of an AAU are correct?

QUESTION 17
Which of the following files must be prepared when remotely commissioning a gNodeB using the MAE Deployment?

QUESTION 18
Which of the following functions are implemented by the UBBP board in the BBU5900?

QUESTION 19
Which of the following devices is used to implement service slicing on the 5G RAN side?

QUESTION 20
If the length of the CPRI optical fiber between a BBU and an RRU exceeds 150 m, you are advised to use a multimode fiber.

QUESTION 21
Which of the following parameters is related to the frequency-domain position of PBCH DMRSs?

QUESTION 22
In what scenarios is GENEX Assistant typically applied?

QUESTION 23
According to 5G eMBB service requirements, which of the following is the minimum rate required for network edge coverage?

QUESTION 24
The RSRP value of the test terminal can be viewed on the GENEX Probe. Which of the following test results indicate good signal quality?

QUESTION 25
If multiple IP addresses are planned for a gNodeB and the next-hop IP addresses are different, which of the following route configurations is more suitable?

QUESTION 26
Which of the following statements about the NR slot structure are correct?

QUESTION 27
Which of the following 5G massive MIMO scenarios is more suitable for high rise office building coverage?

QUESTION 28
Which of the following methods can be used to obtain VLAN IDs after a base station is powered on?

QUESTION 29
Which of the following channels (signals) can be used for cell measurement in NR?

QUESTION 30
At which layer is downlink data split implemented over the NR air interface in the NSA Option 3x architecture?

QUESTION 31
Which type of information about NR cells is carried in the neighboring NR cell MRs reported by UEs?

QUESTION 32
Which of the following can be used to check whether an antenna is reversely connected during NR single site verification?

QUESTION 33
Which of the following NR channels or signals supports static and dynamic power control?

QUESTION 34
When you add tracking area information on a gNodeB, an operator ID is bound.

QUESTION 35
A larger CQI value indicates a better channel quality.

QUESTION 36
Which of the following signals is measured by a 5G UE to report channel quality information such as the CQI, RI, and PMI to a gNodeB?

QUESTION 37
In NSA networking, which of the following commands can be used to check whether the Sl-U interface is normal?