[Q257-Q277] Get 100% Passing Success With True 350-401 Exam! [Feb-2023]

NO.257 Which method creates an EEM applet policy that is registered with EEM and runs on demand or manually?

NO.258 Refer to the exhibit.

An engineer must deny HTTP traffic from host A to host B while allowing all other communication between the hosts, drag and drop the commands into the configuration to achieve these results. Some commands may be used more than once. Not all commands are used.

NO.259 Refer to the exhibit.

Which command when applied to the Atlanta router reduces type 3 LSA flooding into the backbone area and summarizes the inter-area routes on the Dallas router?

NO.260 A network monitoring system uses SNMP polling to record the statistics of router interfaces The SNMP queries work as expected until an engineer installs a new interface and reloads the router After this action, all SNMP queries for the router fail What is the cause of this issue?

NO.261 To increase total throughput and redundancy on the links between the wireless controller and switch, the customer enabled LAG on the wireless controller. Which EtherChannel mode must be configured on the switch to allow the WLC to connect?

NO.262 A network engineer is configuring OSPF on a router. The engineer wants to prevent having a route to
177.16.0.0/16 learned via OSPF. In the routing table and configures a prefix list using the command ip prefix-list OFFICE seq S deny 172.16.0.0/16. Winch two identical configuration commands must be applied to accomplish the goal? (Choose two.)

NO.263 Refer the exhibit.

Which configuration elects SW4 as the root bridge for VLAN 1 and puts G0/2 on SW2 into a blocking state?
A)

B)

C)

D)

NO.264 Which feature Is used to propagate ARP broadcast, and link-local frames across a Cisco SD-Access fabric to address connectivity needs for silent hosts that require reception of traffic to start communicating?

NO.265 Refer to the Exhibit.

An engineer is installing a new pair of routers in a redundant configuration. When checking on the standby status of each router the engineer notices that the routers are not functioning as expected. Which action will resolve the configuration error?

NO.266 Drag and drop the LIPS components on the left to the correct description on the right.

NO.267 Drag and drop the characteristics from the left onto the routing protocols they describe on the right.

NO.268 An engineer is describing QoS to a client. Which two facts apply to traffic policing? (Choose two.)

NO.269 Drag and drop the REST API authentication methods from the left onto their descriptions on the right.

NO.270 Refer to the exhibit.

An engineer must configure and validate a CoPP policy that allows the network management server to monitor router R1 via SNMP while protecting the control plane. Which two commands or command sets must be used?
(Choose two.)
A)

B)

C)

D)

E)

NO.271

Refer to the exhibit. A network engineer must configure NETCONF. After creating the configuration, the engineer gets output from the command show line, but not from show running-config. Which command completes the configuration?

NO.272 Based on this interface configuration, what is the expected state of OSPF adjacency?

NO.273 A client with IP address 209.165.201.25 must access a web server on port 80 at 209.165.200.225. To allow this traffic, an engineer must add a statement to an access control list that is applied in the inbound direction on the port connecting to the web server.
Which statement allows this traffic?

NO.274 DRAG DROP

Refer to the exhibit Drag and drop the snippets into the RESTCONF request to form the request that returns this response Not all options are used

NO.275 Which statement explains why Type 1 hypervisor is considered more efficient than Type 2 hypervisor?

NO.276 Drag and drop the characteristics from the left onto the routing protocols they describe on the right.

NO.277 Refer to the exhibit.

Which command set must be added to the configuration to analyze 50 packets out of every 100?