500-220 Dumps PDF 2023 Strategy Your Preparation Efficiently [Q23-Q46]

Rate this post

500-220 Dumps PDF 2023 Strategy Your Preparation Efficiently

Latest Verified & Correct Cisco 500-220 Questions

NO.23 Refer to the exhibit.

Assuming this MX has established a full tunnel with its VPN peer, how will the MX route the WebEx traffic?

WebEx traffic will prefer WAN 2 as long as it meets the thresholds in the “Conf” performance class.

WebEx traffic will prefer WAN 1 as it is the primary uplink.

WebEx traffic will prefer WAN 2 as long as it is up.

WebEx traffic will be load-balanced between both active WAN links.

NO.24 Refer to the exhibit.

A packet arrives on the VPN concentrator with source IP 10.168.70.3 and destined for IP 10.116.32.4.
What is the next hop for the packet, based on this concentrator routing table?

The concentrator gateway (10.128.124.62) is the next hop.

Not enough detail is available to determine the next hop.

The packet is stopped.

The Auto VPN peer “Store 1532 – appliance” is the next hop.

NO.25 Which Cisco Meraki product must be deployed in addition to Systems Manager so that Systems Manager Sentry enrollment can be used?

MS Switch

Meraki Insight

MR Access Point

MV Smart Camera

NO.26 Which Meraki Dashboard menu section is accessed to enable Sentry enrollment on an SSID?

Wireless > Configure > Access Control

Wireless > Configure > Splash page

Wireless > Configure > Firewall & Traffic Shaping

Wireless > Configure > SSIDs

NO.27 What occurs when a configuration change is made to an MX network that is bound to a configuration template?

The configuration change in the bound network is combined with the template configuration inside the template.

The more restrictive configuration is preferred.

The configuration change in the bound network overrides the template configuration.

The template configuration overrides the configuration change in the bound network.

NO.28 Refer to the exhibit.

Which outcome occurs when logging is set to Enabled?

Outbound flows are sent to a configured syslog server if a syslog sender is configured for flows.

The hits counter within this section is now enabled.

This firewall rule is now enabled.

Inbound flows are sent to a configured syslog server if a syslog server configured for flows.

NO.29 Which two actions can extend the video retention of a Cisco Meraki MV Smart Camera? (Choose two.)

enabling audio compression

installing an SSD memory extension

enabling motion-based retention

enabling maximum retention limit

configuring a recording schedule

NO.30 How does a Meraki device behave if cloud connectivity is temporarily lost?

The offline device continues to run with its last known configuration until cloud connectivity is restored.

The offline device reboots every 5 minutes until connection is restored.

The offline device stops passing traffic.

The offline device tries to form a connection with a local backup sever.

NO.31 Refer to the exhibit.

What are two outcomes reflected in the Web App Health application? (Choose two.)

Users on both networks may be experiencing issues when attempting to reach Google.

Network #1 could not load Google because of a remote server issue.

Network #2 had better application performance than Network #1.

Network #2 could not load Google because of a local client misconfiguration.

Neither network recorded any server-side performance issues.

NO.32 Which Cisco Meraki best practice method preserves complete historical network event logs?

Configuring the preserved event number to maximize logging.

Configuring the preserved event period to unlimited.

Configuring a syslog server for the network.

Configuring Dashboard logging to preserve only certain event types.

NO.33 What is the best practice Systems Manager enrollment method when deploying corporate-owned iOS devices?

manual

Apple Configurator

Sentry enrollment

DEP

NO.34 Refer to the exhibit.

Which two actions are required to optimize load balancing asymmetrically with a 4:1 ratio between links? (Choose two.)

Change the primary uplink to “none”.

Add an internet traffic preference that defines the load-balancing ratio as 4:1.

Enable load balancing.

Set the speed of the cellular uplink to zero.

Change the assigned speeds of WAN 1 and WAN 2 so that the ratio is 4:1.

NO.35 Which VLAN is used to source pings across the site-to-site VPN when using the MX Live tools?

highest VLAN ID that is configured and set to NO to use VPN

lowest VLAN ID that is configured and set to YES to use VPN

highest VLAN ID that is configured and set to YES to use VPN

lowest VLAN ID configured and set to NO to use VPN

NO.36 Drag and drop the steps from the left into the sequence on the right to manage device control, according to Cisco Meraki best practice.

NO.37 For which two reasons can an organization become “Out of License”? (Choose two.)

licenses that are in the wrong network

more hardware devices than device licenses

expired device license

licenses that do not match the serial numbers in the organization

MR licenses that do not match the MR models in the organization

NO.38 Refer to the exhibit.

This Dashboard organization uses Co-Termination licensing model.
What happens when an additional seven APs are claimed on this network without adding licenses?

All APs immediately stop functioning.

All network devices stop functioning in 30 days.

One AP Immediately stops functioning.

All APs stop functioning in 30 days.

NO.39 Which three verbs of request are available in the Cisco Meraki API? (Choose three.)

SET

PUT

PATCH

ADD

POST

GET

NO.40 Which design requirement is met by implementing syslog versus SNMP?

when automation capabilities are needed

when proactive alerts for critical events must be generated

when organization-wide information must be collected

when information such as flows and client connectivity must be gathered

NO.41 Which API endpoint clones a new Organization?

POST /organizations/clone/{organizationId}

PUT /organizations/{organizationId}/clone

POST /organizations/{organizationId}/new

POST /organizations/{organizationId}/clone

NO.42 Drag and drop the descriptions from the left onto the corresponding MX operation mode on the right.

NO.43 Which configuration step is necessary when automatic updating is required of iOS apps provisioned through Systems Manager that are found in the App Store?

No configuration step is necessary; automatic updating is the default behavior.

Configure automatic updating of iOS devices in the Meraki installed profile.

Create a security policy that enables automatic updates.

Create a profile with automatic update enabled and apply it to iOS devices.

NO.44 Where should a network admin navigate to investigate wireless mesh information between Meraki APs?

Wireless > Monitor > Access Points > AP > RF

Wireless > Configure > Radio Settings

Wireless > Monitor > Wireless Health

Wireless > Monitor > RF Spectrum

NO.45 Drag and drop the settings from the left into the boxes on the right to indicate if the setting will be cloned or not cloned using the Cisco Meraki MS switch cloning feature.