[Q19-Q33] Pass EMC Specialist – Implementation Engineer, Campus Networking Exam Exam in First Attempt Guaranteed Updated Dump from Real4dumps!

Q19. Which AAA method is only used for 802.1x and never returns an error?

Q20. A user’s workstation is connected to an IP phone that is connected to a Dell EMC N-Series switch.
Which type of traffic is typically tagged or untagged?

Q21. When configuring a Dell EMC N-Series switch for voice traffic, which settings are needed?

Q22. In a traditional campus network design using a three-tier hierarchical model, what are the key attributes of the Core layer in this model?

Q23. After setting up the VoIP configuration, a network administrator issues the following commands with the results shown:
console# show voice vlan
Administrative Mode………………………Enable
console# show voice vlan it gi 1/0/2
Interface………………………………….Gi1/0/2
Voice VLAN Interface Mode……………Enabled
Voice VLAN ID………………………….10
Voice VLAN COS Overwrite……………False
Voice VLAN DSCP Value……………….46
Voice VLAN Port Status…………………Enabled
Voice VLAN Authentication…………….Disabled
Based on this information, what is the Layer 3 QoS value?

Q24. Two switches are part of the same VRRP group with the following priorities configured:
Switch1: Priority 110
Switch2: Priority 90
Switch2 is required to be the Master if interface GigabitEthernet 0/2 on Switch1 fails. Which configuration should be part of the setup?

Q25. A user’s workstation has an IP phone connected to a Dell EMC N-Series switch.
What is the recommended number of VLANs that should be configured on the switch port?

Q26. Exhibit:

The exhibit represents a topology with all Dell EMC N4000 Series switches with RSTP enabled. In addition, the switches are using the default configuration on all ports and protocols.
Which port number will be blocked by spanning tree?

Q27. A user’s host with an IP address of 172.16.1.22/24 is attempting to FTP a file from the server with IP address
10.1.1.99; however, they are unable to connect.
Which access-list is preventing this traffic?
# ip access-list ACL1

Q28. Refer to the Exhibit.
Switch-1(config)# radius server host 10.1.1.111
Switch-1(config-radius)# key “secretkey”
Switch-1(config-radius)# exit
Switch-1(config)# aaa authentication login “LOCAL-AUTH” local
Switch-1(config)# aaa authentication login “REMOTE-AUTH” radius local
Switch-1(config)# aaa authentication enable “REMOTE-AUTH” radius enable Switch-1(config)# aaa authentication login default tacacs local Switch-1(config)# aaa authentication enable default tacacs enable Switch-1(config)# line telnet Switch-1(config-telnet)# login authentication “REMOTE-AUTH” Switch-1(config-telnet)# exit Switch-1(config)# line ssh Switch-1(config-ssh)# login authentication default Switch-1(config)# exit Switch-1(config)# line console Switch-1(config-line)# login authentication “LOCAL-AUTH” Switch-1(config-line)# exit Which authentication method will be used if a user tries to log into the switch when accessing through SSH?

Q29. A Dell EMC N-Series switch is configured to uplink to a customer switch using two separate 4-port port- channels configured as trunks. Both switches are configured with 16 VLANs and RSTP.
How will VLAN traffic be distributed across the port-channels?

Q30. Switch-1(config)# interface tengigabitethernet 1/0/1
Switch-1(config)# switchport mode access
Switch-1(config)# switchport trunk allowed vlan 10, 20
Switch-1(config)#
Switch-1(config)# interface tengigabitethernet 1/0/3
Switch-1(config)# switchport mode access
Switch-1(config)# switchport access vlan 10
Switch-2(config)# interface tengigabitethernet 1/0/2
Switch-2(config)# switchport mode trunk
Switch-2(config)# switchport trunk allowed vlan 10, 20
Switch-2(config)#
Switch-2(config)# interface tengigabitethernet 1/0/6
Switch-2(config)# switchport mode access
Switch-2(config)# switchport access vlan 20

A network administrator is troubleshooting why Host 1 cannot communicate with Host 2.
Based on the switch output shown in the exhibit, what is the reason for the communication issue?

Q31. Which interface on a Dell EMC N-Series switch provides the most security for management?

Q32. Which spanning tree feature will prevent unnecessary timeouts from DHCP servers?

Q33. What describes the POE+ capabilities of the Dell EMC N1100P Series?