New JN0-682 Test Materials & Valid JN0-682 Test Engine [Q20-Q40]

NO.20 Referring to the exhibit, not all routes are being exchanged by EBGP peers.

In this scenario, which BGP parameter would solve this problem?

NO.21 You are asked to configure JTI on the QFX Series devices in your data center fabric. You must use sensors with the least amount of latency. Which type of sensor should you use in this scenario?

NO.22 Which two statements define the use of route targets and route distinguishers in an EVPN? (Choose two.)

NO.23 Which two statements are correct about VXLANs? (Choose two.)

NO.24 You are asked to deploy an Ethernet bridging design in a data center with the following criteria:
–routing must occur on the leaf devices.
–VTEPs must terminate on the leaf devices.
–facilitate inter-VLAN communication, — lower latency with East-West traffic.
Which architecture should you use in this scenario?

NO.25 You are troubleshooting an L3VPN that is part of an EVPN/MPLS DCI. You notice that the EVPN overlay
BGP session toward 10.29.50.4 is unable to establish.

Why is the BGP session failing to establish?

NO.26 Click the exhibit button.

Referring to the exhibit, which two statements are correct? (Choose two.)

NO.27 Your colleague has begun working on the base configuration for an active-active multihomed EVPN
connection shown in the exhibit.

Which two actions will ensure a successful implementation? (Choose two.)

NO.28 You are configuring VXLAN. and you must ensure that all switches for the multicast groups advertise their
existence and learn about other VTEPs In this scenario. which protocol will accomplish this task?

NO.29 Exhibit.

Referring to the exhibit, you have a data center in which only the spine devices are using EVPN and VXLAN. The leaf nodes are multihomed in active-active mode to the spine nodes through ESI LAG interfaces. In this design, a link failure on the interface connecting the spine nodes would also cause all traffic from the spine to the leaf nodes to drop.
In this scenario, which command configured on which nodes would solve this problem?

NO.30 What is the endpoint of a VXLAN tunnel?

NO.31 Exhibit.


The configuration shown in the exhibit is intended to set up assisted replication but will not commit.
Which action will create a valid configuration in this situation?

NO.32 Exhibit.

You choose the EBGP design shown in the exhibit as your IP fabric design. You must ensure that both routes received by the spine nodes will be used for ECMP forwarding Which BGP parameter would need to be added to the EBGP configuration of the spine nodes to achieve this goal?

NO.33 Exhibit.

Referring to the exhibit, which statement is correct?

NO.34 You are designing an EBGP IP fabric for a multi-side data center.
In this scenario, which two statements are true? (Choose two.)

NO.35 You are deploying a switch using ZTP.
Which two statements are true in this scenario? (Choose two.)

NO.36 Which protocol is used between VCF member devices to create a loop-free topology?

NO.37 Which two statements about ZTP are true? (Choose two.)

NO.38 Which EVPN service consists of a single broadcast domain per EVPN instance?

NO.39 What are the two valid types of VXLAN signaling?(Choose two.)

NO.40 What is an advantage that EVPN has over VPLS when used for DC I?