300-730 Dumps PDF 2026 Program Your Preparation EXAM SUCCESS [Q122-Q136]

Rate this post

300-730 Dumps PDF 2026 Program Your Preparation EXAM SUCCESS

Get Perfect Results with Premium 300-730 Dumps Updated 298 Questions

Cisco 300-730 exam is ideal for IT professionals who are looking to specialize in VPN technologies and advanced security. Implementing Secure Solutions with Virtual Private Networks certification is highly regarded in the industry and is recognized by leading organizations around the world. Candidates who pass 300-730 exam will be well-positioned to pursue a variety of career opportunities in the field of network security.

NEW QUESTION 122
Refer to the exhibit. An engineer must configure a FlexVPN site-to-site GRE tunnel that uses iPsec between two Cisco routers. The indicated configuration was applied on Router_B, but the tunnel fails to come up. Which IP address must be set on Router_B to resolve the issue?

192.16.1.1

192.16.1.2

192.168.10.1

192.168.10.2

In the provided configuration snippet from Router_B, the IKEv2 keyring is configured with the following peer entry:
crypto ikev2 keyring ciscokeys
peer Router_A
address 127.0.0.1
pre-shared-key Cisco4512!
The issue here is that the address 127.0.0.1 (loopback) is incorrectly set as the peer’s address. In a site-to-site FlexVPN with GRE over IPsec, the public IP address of Router_A should be used as the peer address instead.
Router_A’s public IP address is 192.16.1.1, so Router_B’s configuration should be updated as follows:
crypto ikev2 keyring ciscokeys
peer Router_A
address 192.16.1.1
pre-shared-key Cisco4512!
This change ensures that Router_B correctly identifies Router_A using its real public IP address instead of an invalid loopback address.

NEW QUESTION 123
Which two changes must be made in order to migrate from DMVPN Phase 2 to Phase 3 when EIGRP is configured? (Choose two.)

Add NHRP shortcuts on the hub.

Add NHRP redirects on the spoke.

Disable EIGRP next-hop-self on the hub.

Enable EIGRP next-hop-self on the hub.

Add NHRP redirects on the hub.

DMVPN disables the EIRGP next-hop-self with “no ip next-hop-self eigrp xxx” in DMVPN phase
2, and to go from Phase 2 to 3 you need use the NHRP protocol, and again enable EIRGP next- hop-self with “ip next-hop-self eigrp 134” under the tunnel interface.
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_conn_dmvpn/configuration/15-mt/sec- conn-dmvpn-15-mt-book/sec-conn-dmvpn-dmvpn.html#GUID-BF561439-BCC0-4AAF-80D9-
1F7876CB7B81

NEW QUESTION 124
Refer to the exhibit. A network administrator is setting up a phone VPN on a Cisco ASA. The phone cannot connect and the error is presented in a debug on the Cisco ASA. Which action fixes this issue?

Enable web-deploy of the posture module so that the module can be downloaded from the Cisco ASA to an IP phone.

Configure the Cisco ASA to present an RSA certificate to the phone for authentication.

Disable Cisco Secure Desktop under the connection profile VPNPhone.

Install the posture module on the Cisco ASA.

CSD and IP phones: Currently, IP phones do not support Cisco Secure Desktop (CSD) and do not connect when CSD is enabled for the tunnel group or globally in the ASA.

NEW QUESTION 125
An organization wants to distribute remote access VPN load across 12 VPN headend locations supporting 25,000 simultaneous users. Which load balancing method meets this requirement?

one VPN profile per site

DNS-based load balancing

AnyConnect native load balancing

equal cost, multipath load balancing

NEW QUESTION 126
Refer to the exhibit. Which two commands under the tunnel-group webvpn-attributes result in a Cisco AnyConnect user receiving the AnyConnect prompt in the exhibit? (Choose two.)

group-url https://172.16.31.10/General enable

group-policy General internal

authentication aaa

authentication certificate

group-alias General enable

NEW QUESTION 127
Refer to the exhibit. Which VPN technology is allowed for users connecting to the Employee tunnel group?

SSL AnyConnect

IKEv2 AnyConnect

crypto map

clientless

The tunnel-group Employee has no entry for a specific default-group-policy as with the Admin- Group.
The group-policy DfltGrpPolicy is used instead. This permits only ssl-clientless.

NEW QUESTION 128
An engineer is implementing the FlexVPN solution on a Cisco IOS router. The router must only terminate VPN requests and must not initiate them. Additionally, the interface must support VPNs from other routers and Cisco AnyConnect connections. Which interface type must be configured to meet these requirements?

point-to-point GRE tunnel interface

multipoint GRE tunnel interface

static virtual tunnel interface

virtual template interface

The correct interface type to meet these requirements is the virtual template interface. This interface allows for the creation of multiple virtual access interfaces, which can be used for various types of remote access VPN connections, including site-to-site and AnyConnect VPNs.
The virtual template interface can be configured to terminate VPN requests from other routers and allow for dynamic creation of VPN sessions, while also supporting AnyConnect VPN connections.

NEW QUESTION 129
Refer to the exhibit.

Which two conclusions should be drawn from the DMVPN phase 2 configuration? (Choose two.)

Next-hop-self is required.

EIGRP neighbor adjacency will fail.

EIGRP is used as the dynamic routing protocol.

EIGRP route redistribution is not allowed.

Spoke-to-spoke communication is allowed.

The premise is that we are looking at a DMVPN phase 2 configuration. That means that spoke-to-spoke traffic should be allowed. Remember that phase 2 requires the “no ip next-hop-self” command with EIGRP

NEW QUESTION 130
An engineer must design a VPN solution that meet these requirements:
– internet connections to the cloud
– creates a private tunnel for direct communication between corporate
sites
– encrypts the tunnels by using IPsec
Which technology must be used?

SSL VPN

GET VPN

WebVPN

DMVPN

Dynamic Multipoint VPN is designed for IPsec-encrypted, site-to-site tunnels over the internet, allowing corporate sites to build private, direct tunnels to each other across a cloud network. It uses mGRE and NHRP with IPsec to securely interconnect multiple locations over an untrusted network such as the internet.

NEW QUESTION 131
Which transport does Cisco AnyConnect use to carry tunneled data traffic more efficiently for latency-sensitive applications after the TLS session is established?

DTLS over UDP 443

IKEv2 over UDP 500

ESP over UDP 4500

TLS over TCP 80

AnyConnect negotiates the session over TLS on TCP 443 and then attempts to move data traffic to DTLS on UDP 443. DTLS avoids the TCP-over-TCP performance penalty and is better suited to real-time traffic such as voice and video, falling back to TLS if UDP is blocked.

NEW QUESTION 132
What is the purpose of group members in a Cisco Group Encrypted Transport VPN architecture?

It services registration requests.

It supplies group authentication keys.

It provides an encryption service.

It holds group authentication keys.

In a Cisco Group Encrypted Transport VPN (GETVPN), group members are the routers that actually encrypt and decrypt the data-plane traffic using the keys learned from the key server.
They apply the group security policies and perform the encryption service for transit traffic across the core.

NEW QUESTION 133
After a user configures a connection profile with a bookmark list and tests the clientless SSLVPN connection, all of the bookmarks are grayed out. What must be done to correct this behavior?

Apply the bookmark to the correct group policy.

Specify the correct port for the web server under the bookmark.

Configure a DNS server on the Cisco ASA and verify it has a record for the web server.

Verify HTTP/HTTPS connectivity between the Cisco ASA and the web server.

NEW QUESTION 134
An administrator is deciding which authentication protocol should be implemented for their upcoming Cisco AnyConnect deployment. A list of the security requirements from upper management are: the ability to force AnyConnect users to use complex passwords such as C1$c0451035084!, warn users a few days before their password expires, and allow users to change their password during a remote access session. Which authentication protocol must be used to meet these requirements?

LDAPS

RADIUS

Kerberos

TACACS+

To enforce complex passwords–for example, to require that a password contain upper- and lowercase letters, numbers, and special characters–enter the password-management command in tunnel-group general-attributes configuration mode on the ASA and perform the following steps under Active Directory.
https://www.cisco.com/c/en/us/td/docs/security/asa/asa97/configuration/vpn/asa-97-vpn- config/vpn-groups.html

NEW QUESTION 135
A network engineer is setting up Cisco AnyConnect 4.9 on a Cisco ASA running ASA software 9.1. Cisco AnyConnect must connect to the Cisco ASA before the user logs on so that login scripts can work successfully. In addition, the VPN must connect without user intervention. Which two key steps accomplish this task? (Choose two.)

Create a Network Access Manager profile with a client policy set to connect before user logon.

Create a Cisco AnyConnect VPN profile with Start Before Logon set to true.

Issue an identity certificate to the trusted root CA folder in the machine store.

Create a Cisco AnyConnect VPN profile with Always On set to true.

Create a Cisco Anyconnect VPN Management Tunnel profile.

NEW QUESTION 136
Refer to the exhibit. A network engineer is reconfiguring clientless SSLVPN during a maintenance window, and after testing the new configuration, is unable to establish the connection. What must be done to remediate this problem?

Enable client services on the outside interface.

Enable clientless protocol under the group policy.

Enable DTLS under the group policy.

Enable auto sign-on for the user’s IP address.

Loading …

Cisco 300-730 exam is designed for network security engineers and administrators who want to specialize in virtual private networks (VPN) and secure remote access solutions. Implementing Secure Solutions with Virtual Private Networks certification exam covers the implementation of secure VPN solutions using Cisco technologies, including Cisco AnyConnect, Cisco ASA, and Cisco IOS routers. Passing 300-730 exam validates the candidate’s knowledge and skills in deploying and managing VPN solutions for secure remote access to enterprise networks.

300-730 PDF Dumps Extremely Quick Way Of Preparation: https://www.real4dumps.com/300-730_examcollection.html

300-730 Dumps PDF 2026 Program Your Preparation EXAM SUCCESS [Q122-Q136]

Leave a Reply Cancel reply

Related Posts

New 2023 Realistic 350-401 Dumps Test Engine Exam Questions in here [Q145-Q167]

Jul 18, 2026 Updated 810-110 Dumps Questions For Cisco Exam [Q31-Q45]

[Dec 03, 2024] Download Free Cisco 300-425 Real Exam Questions [Q18-Q39]