[Dec 14, 2023] Real4dumps 300-410 Exam Practice Test Questions (Updated 563 Questions) [Q251-Q266]

QUESTION 251
Refer to the exhibit.

QUESTION 252
Drag and drop the DHCP messages from the left onto the correct uses on the right.

QUESTION 253
Refer to the exhibit.

An engineer is trying to configure local authentication on the console line, but the device is trying to authenticate using TACACS+.
Which action produces the desired configuration?

QUESTION 254
Refer to the exhibit.

An engineer must configure a LAN-to-LAN IPsec VPN between R1 and the remote router. Which IPsec Phase 1 configuration must the engineer use for the local router?

QUESTION 255
Which method changes the forwarding decision that a router makes first changing the routing table or influencing the IP data plane?

QUESTION 256
Refer to the exhibit.

In which circumstance does the BGP neighbor remain in the idle condition?

QUESTION 257
What is a limitation of IPv6 RA Guard?

QUESTION 258


Refer to me exhibit Traffic from R3 to the central site does not use alternate paths when R3 cannot reach 10 10
10 2 Traffic on R3 destined to R4 takes an alternate route via 10 10 10.6 when 10 10 10 4 is not accessible from R3 Which configuration switches traffic destined to 10 10 10 2 from R3 on the alternate path”

QUESTION 259
Exhibit:

NTP is configured across the network infrastructure and Cisco DNA Center. An NTP issue was reported on the Cisco DNA Center at 17:15. Which action resolves the issue?

QUESTION 260
Refer to the exhibit.

The Math and Science departments connect through the corporate. IT router but users in the Math department must not be able to reach the Science department and vice versa Which configuration accomplishes this task?

QUESTION 261
Refer to the exhibit.

A network is under a cyberattack. A network engineer connected to R1 by SSH and enabled the terminal monitor via SSH session to find the source and destination of the attack. The session was flooded with messages, which made it impossible for the engineer to troubleshoot the issue. Which command resolves this issue on R1?

QUESTION 262
An engineer configured Reverse Path Forwarding on an interface and noticed that the routes are dropped when a route lookup fails on that interface for a prefix that is available in the routing table Which interface configuration resolves the issue?

QUESTION 263

Refer to the exhibit. The engineer configured and connected Router2 to Router1. The link came up but could not establish a Telnet connection to Router1 IPv6 address of 2001:DB8::1. Which configuration allows Router2 to establish a Telnet connection to Router1?

QUESTION 264
Refer to the exhibit.

Which action makes 10.1.3.2 the feasible successor to reach 10. 200. 1 0/24 for location S42T447E33F95?

QUESTION 265
Which control plane process allows the MPLS forwarding state to recover when a secondary RP takes over from a failed primary RP?

QUESTION 266
Refer to the exhibit.

An engineer is trying to block the route to 192.168.2.2 from the routing table by using the configuration that is shown. The route is still present in the routing table as an OSPF route. Which action blocks the route?